Home > Products > EPDM Rubber Patch Kit

EPDM Rubber Patch Kit

The Seal Trust™ EPDM Rubber Patch Kit is an all-in-one solution to repair small holes or tears in EPDM rubber membrane. The kit can also be used for T-Patches (qty 4). The kit contains 4- 8” round cured EPDM Patches, 1 pint of Tape Primer, 1 Scrubbing pad and a Seam Roller.

Contents 4x 8.5″ Round Patches, 1x Pint of Primer, 1x Roller, 1x Scrubber Pad
Patch Color Black
Patch Sizes 8.5″
Nominal Thickness 68 mils
Adhesive Type Butyl-based
Adhesion To most clean, dry substrates/surfaces
Application Temperature Temperature must maintain 40°F and above for at least 48 hours
Resistant to Weather, water and water vapor, (5%) acidic or basic solutions
Effected by Petroleum, grease, oil, solvents, vegetable oils, and animal fats
Primer Volume 1 Pint
Coverage Amount 25 Sq. Ft. of Primer
Storage Store in warehouse without excessive heat. Do NOT store long term on roof
Shelf Life 1 year if stored between 60°F and 80°F

Application Instructions

Clean and dry membrane. Scrub in Tape Primer using scrubber pad in an area slightly larger than the disk needs. Use gloves and eye protection. Allow the primer to flash off, or dry to the point that when touching the primed area with a finger, it feels tacky and no strings are visible.

Remove half of the paper backing from the disk and fold in half with the EPDM side facing itself.

Install one half of the disk onto the membrane starting in the center, then roll the rest of the exposed half down. This is to help prevent fish mouths or wrinkles. Remove the paper backing from the other half and lay down onto the membrane just like before.

Roll with a included roller to ensure a good bond between disk and membrane.

Frequently Asked Questions

The EPDM Patch Kits are an all-in-one solution to repair small holes or tears in EPDM rubber membranes. The kit can also be used for T-Patches. The patch kit contains Primer, Patches, Seam Roller, and a Scrubbing Pad.

EPDM Rubber Patch Kit
x