Copyright © SealCorp USA. All Rights Reserved | Privacy policy | Sitemap

Low VOC Splice Wash


Low VOC Splice Wash


Download Product Data SheetDownload Safety Data Sheet

Available in 1 gallon cans

Product Information:

Splice Wash is a clear solvent used to clean dirt and containments from single ply roof systems. Especially used on old membranes to remove dirt prior to application of tape primers or seam adhesives. Change rags or applicator pads frequently! Do not allow product to puddle on EPDM or TPO for long periods of time. Discarded rags should be disposed of properly and will be a flammable hazard. No smoking or open flames on the roof while using this product. This Low VOC formula is for use in OTC states.

Application Instructions:

This product should be scrubbed into the EPDM or TPO surfaces thoroughly to remove surface debris. Change rags frequently. Always clean an area in excess of the area to be covered. When used with clean membranes such as EPDM or TPO this wash is not required. Use solvent resistant gloves when using this product.

SKU: Category: Tags: , , , ,

Low VOC Splice Wash Physical Properties:

Color: Clear
Viscosity (eps): Water thin
Density (#/GAL.): 7.63#
Solids: 0
Flash Point (F): 3.9F TCC
Base: Solvent
Solvent System: Ester/Aromatic blend
Clean-up Solvent: N/A
Storage: May be stored outside if protected from water.
Packaging: 1 gallon (6 gal/cs)

Hazards: Extremely flammable. Avoid repeated skin contact or the breathing of concentrated vapors. Use in well ventilated areas away from heat, sparks, fire, flame and ignition sources. Vapors are heavier than air and may travel a considerable distance to an ignition source and flash back. Do not inhale vapors above TLV as listed on the SDS.

Freight Classification:  UN1133, ADHESIVE, 3 PGII NMFC# 170060 CLASS 60


Weight-201808-- lbs
Dimensions-201808-- × -201808-- × -201808-- in