Pipe Boot

$0.00


Available in Black or White and pipe sizes ranging from 1-3″ or 1-6″

EPDM Pipe Boot  Information

Seal Trust™ Pipe Boots are pre-molded EPDM accessory for flashing pipes or stacks protruding from the roof on single ply membrane installations such as EPDM and TPO. Pipe Boots are installed over vent stacks and pipes usually on flat roof surfaces. The boots all come pre-taped for easy installation with a flange that installs to the membrane in a peel and stick application. The boots come with two piece release paper for easy use.

Application Instructions:

Always clean and prime membrane using roofing industry standard products for tape applications such as Seal Trust™ F-Primer or Low VOC Tape Primer. Usual installation requires primer installed on or about 4-5 inches away from each pipe. Then measure the diameter of the pipe and cut the boot at one size smaller than the pipe (i.e. 4” stack cut at 3” level) and stretching over the pipe. Before pipe boot installation Water Cut Off Caulk should be installed on the pipe for maximum protection. Pipe clamp is provided and required for final step.

SKU: https://sealtrustroofing.com/wp-content/uploads/2018/08/tpo-seam-tape.png Category:

Description

Resistant to: Weather, water & water vapor, (5%) acidic or basic solutions
Effected by: Petroleum, grease, oil, solvents, vegetable oils, and animal fats
Product Storage: Store in warehouse without excessive heat. Do NOT store long term on roof.
Shelf Life: 1 year if stored between 60° and 80° F.

Physical Properties:

Color: Black
Solids: 100%
Odor: Slight Hydrocarbon
Penetration: (ASTM D 217) : 100/130 mm
Volatile: % by Volume: None
Adhesion: To most clean, dry substrates/surfaces

Additional information

Weight .-201808--. lbs
Dimensions .-201808--. × .-201808--. × .-201808--. in

Reviews

There are no reviews yet.

Be the first to review “Pipe Boot”

Your email address will not be published. Required fields are marked *